Supports 4-pair or 8-pair VDSL2 bonding in upstream transmission and supports vectoring. The MA5694 provides four or eight xDSL ports. Supports GPON, EPON, or GE upstream transmission. MA5694 provides 2x XPON/GE uplink ports, 4/8x xDSL uplink ports, 4xGE ports, 2xFE ports. The system supports the baud rates of 9600 bit/s, 19200 bit/s, 38400 bit/s, 57600 bit/s, and 115200 bit/s.Huawei SmartAX MA5694 Multi-service Access Module is an indoor box-shaped ONU for small-cell backhaul and small- and medium-sized enterprise (SME) private line service access. In this case, set the consistent baud rate for the CRT (or HyperTerminal ) to log in to the system. (3)If illegible characters are displayed on the CRT (or HyperTerminal ) interface after you log in to the system, it is generally because the baud rate of the CRT (or HyperTerminal ) is different from the baud rate of the different equipment. You can select COM1 or COM2 (here, use COM8 as an example).

(2)Select the right serial port that is connected to the equipment. By default, the baud rate of the serial port is 9600 bit/s. (1)The baud rate of the CRT (or HyperTerminal ) must be the same as the baud rate of the serial port on the equipment. Port is read out by the previous step of native COM Port, it is assumed that as the COM8, baud rate to 9600 – bit/s, bits of 8, no parity, Stop bit is 1, no the data flow control.Īfter click connection, which will be shown below, enter account and password interface. Out the inserted COM port, for the next steps.Ĭlick in sequence: File – the Quick Connect, new connection option, use serial protocol, RS232 turn USB cable driver load is normal, and from my computer – device manager can read Secure CRT (also can use software such as hyperterminal or putty to replace)ĭownload and install the software, select the default Settings.Īfter installed the software, needed to be even good situation in the Console line, Serial port cable (the Console line, RJ45 – RS232 line configuration): RJ45 – RS232 Console cable USB to serial port USB-RS232 cableĬonnection mode: RJ45 connector connected to the Console port equipment, through RS232 joint connection among them, the USB is connected to the computer. Software: serial port driver (with serial port), Putty, Xshell, Secure CRT or HyperTerminal application. Hardware: Computer, serial port cable, a serial port turn USB cable (computer without RS232 interface).Īn RS-232 serial port cable (one end with an RJ-45 connector and the other end with a DB-9 or DB-25 female connector)Ģ. When you need to maintain and manage the Huawei equipment ( include OLT / MDU / Switch / Router and so on ) locally, you can log in to the system through the local serial port.ġ. How to Login Huawei OLT Through Local Console / Serial Port ?

Panduan login huawei smartAX MA5694